It's a highly efficient bubble plate column still. It can be used to distill ethanol (fuel alcohol), spirits (whiskey, Bourbon, vodka, gin, tequila, "moonshine, " and more), and essential oils. Compatible with electric hot plates.
Compatible with propane turkey fryers. Compatible with anything with 2 inch tri clamp. Complete crystal reflux still column with copper bubble plates. Ideal to fit any boilers, beer kegs that have 2 tri clamp port on top. The system is made of Durable Easy-to-clean stainless steel 304 and t2 lead free copper which is a guarantee for a lifetime of use.The glass design will allow you to view the entire distillation processes from the start to the end. This will definitely be an eye catcher in your distillery. 2" tri clamp bottom flanges are made to clamp to any 2" tri clamp opening, or beer keg! We also sell an adapter to make it fit the top of the Robobrew, Grainfather, Turboboiler, Mash and Boil or any lid with a 17mm hole. NOTE : Glass sections connect with special slotted silicone gaskets now, much better and safer than the stainless rings shown in the picture which were expensive and cracking the glass.
Keywords: alcohol distiller, vodka still, whiskey still, moonshine still, distillation column, distillation equipment, home alcohol distiller, flute still, copper still. Items needed for assembling the four 2 inch glass column with copper bubble plates. 4copper bubble downcomers with caps. 4stainless steel rods with nuts.Put the copper bubble caps on the copper downcomers to get them connected together, and then put the complete copper bubble plates into the glass gaskets, the final part of this step is to put them on one of the flanges, as following: see picture for "step 1" in images above. Put one of the glasses on the glass gasket that is put on the flange, then put the complete copper bubble plates into the glass gasket again and put them on the top of the first glass, as following: see picture for step 2 in images above. Repeat the Step 2(put the complete copper bubble plates into the glass gasket again and put them on the top of the next glass) till we use all the glasses. As following: See picture for Step 3 in images above.
Put the flat gasket on the top of the final glass, and then put the rest flange on the top of the flat gasket. By using all the rods and nuts to get the column tight. This item is in the category "Home & Garden\Kitchen, Dining & Bar\Brewing, Distilling & Wine Making\Equipment". The seller is "lionbrewingsolutions" and is located in this country: US.This item can be shipped worldwide.